DIY Faux Stained Glass Tutorial

Hello, my crafty friends! I'm so excited and grateful that you've decided to join me for this faux stained glass project. Grab your kit, and let's get started!

What’s Included in Your Kit?

Your kit contains everything you need to create a beautiful faux stained glass piece. Click here to purchase a kit.

Also, the following thumbnail image will lead you directly to the accompanying YouTube tutorial. A visual guide to creating your Faux Stained Glass masterpiece!

Additional Items You'll Need:

• Hair Dryer, Heat Tool, or Embossing Gun – Used to remove bubbles from the resin.

• Mixing Tool – You can use the opposite end of your paintbrush, a silicone spatula, or a coffee stir stick.

• Ventilated Workspace – Ensure proper airflow while working with resin.

• Gloves (Optional but Recommended) – Helps keep your hands clean and protected.

Step-by-Step Instructions

1. Prepare Your Acrylic Blank

• Peel off the protective film from both sides.

• Select your pattern and place it underneath the acrylic sheet.

• Secure it in place with tape, leaving about half an inch at the bottom for the base slot.

2. Apply the Faux Leading

• Transfer the leading paste into a piping bag.

• Cut a small opening (about 1/8 inch) at the tip.

• Carefully trace the lines of your pattern with the leading paste.

• Let it dry for a few hours (overnight is best), or proceed carefully to the next step.

3. Mix and Apply the Resin

IMPORTANT: Please follow the manufacturer's directions on using resin. 

• Warm up the resin bottles in a cup of warm water for easier mixing.

• Measure equal parts of A and B (start with 2.5ml of each) in a measuring cup.

• Stir well for 4–5 minutes, scraping the sides to ensure thorough mixing.

• Add pigment powder to the resin and mix until smooth.

• Use the brush or a dropper to carefully apply the colored resin into each section of your design.

• Work on one color at a time to prevent mistakes.

4. Remove Air Bubbles

• Use a heat tool, hair dryer, or embossing gun on low to gently heat the resin.

• Watch as bubbles rise to the surface and pop.

5. Let It Cure

• Allow the piece to cure for at least 24 hours in a dust-free, level area.

• Check after 4 hours for thin spots and touch them up if necessary. After full curing, you’ll need to sand before adding more resin.

Final Thoughts

Your stained glass masterpiece is now complete! You’ll have enough materials left over for another project, so feel free to experiment on a picture frame or glass panel. I’d love to see your creations—share your finished pieces with me!

Happy crafting!